Hitachi RX - Page 94

●Communication Timing 5-48
No. Transmission type Conditions
T2 Minimum time (ms)
Remarks
Within 24 items 25 items or more
1 Print description
The print message transfer
ACK condition is t=fixed.
(M: Number of
communication
characters)
(M: Number of
communication
characters)
*6 *9
The print message transfer
ACK condition is t=async.
00
2 Print data recall
When the character height, character
width, character orientation, ink drop
use percentage, or print format changes
before or after recall
400 400 *7
When the character height,
character width, character orientation,
ink drop use percentage, or print format
does not change before or after recall
40 40 *8
3
Print data
registration
-3030
4
Print conditions
Print specifications 400 400 *7
5 Print format 400 400 *7
6 Overall column setup 200 200 *8
7
User pattern
character
-2525
8 Date/time setup -
(M: Number of
printing
characters)
(M: Number of
printing
characters)
*6
External
device
IJprinter
ETX
ACK
STX
ENQ
ACK
5ms(*5)
T2
Printing
operation
Printstartsignal
(2) Time interval (T2) between IJ printer response and printing start
● The IJ printer executes an internal process to make printing preparations in accordance with the received print
data. Do not enter the print start signal during internal process execution.
● In the overwrite-protected mode, initiate the next communication after completion of printing.
● In the overwrite-enabled mode, the next communication can be transmitted during printing, but the ACK/
NAK response does not return until the ongoing printing operation is complete. (t=async.)
● When a print start signal is input with shorter timing than T2, the fault "Print data changeover in progress M"
occurs.
● The more different items of the print format, the longer the time until ready to print.
*5 If the communication time interval is not sufficiently secured, it may not operate normally.
*6 When there is a data matrix and QR code setting, the time is as follows:
*7 When there is a QR code setting, T2 Minimum time is 400xN (ms) (N : Number of QR codes).
*8 When there is a QR code setting, the time is as follows:
M
10
+15
M
10
+30
M
10
+15
M
10
+45
Time T2 when there is a data matrix and QR code setting
Character size
T2 Minimum time (ms)
Within 24 items 25 items or more
Data matrix
5x8 8x N+20 100
12x16, 18x24 15x N+40 150
QR code
QR (21x21) 200xN 200xN
QR (25x25) 300xN 300xN
QR (29x29) 400xN 400xN
(N : Number of 2-Dimensional codes)