Inverter MODBUS RTU Driver
GP-Pro EX Device/PLC Connection Manual
2
Introduction
This manual describes how to connect the Display and the External Device (target Inverter).
In this manual, the connection procedure is described in the sections identified below:
1
System Configuration
This section lists the types of External
Devices and SIO that you can connect.
)"1 System Configuration" (page 3)
2
External Device Selection
Select a model (series) of the External
Device and its connection method.
)"2 External Device Selection" (page 6)
3
Communication Settings
This section shows setting examples for
communicating between the Display and
the External Device.
)"3 Communication Settings" (page 7)
4
Setup Items
This section describes communication
setup items on the Display.
Set the Display’s communication settings
in GP Pro-EX or in offline mode.
)"4 Setup Items" (page 19)
5
Cable Diagrams
This section shows cables and adapters
for connecting the Display and the
External Device.
)"5 Cable Diagrams" (page 23)
Operation
To Next Page
Loading...
