Inverter MODBUS RTU Driver
GP-Pro EX Device/PLC Connection Manual
41
6 Supported Devices
The following table shows the range of supported device addresses. Please note that the actually supported range
of the devices varies depending on the External Device to be used. Please check the actual range in the manual of
your External Device.
Enter the External Device address in the dialog below.
6.1 X200 series
This address can be specified as system data area.
1. Address Enter the address.
2. Reference Available parameter list is displayed.
Click the parameter to use and press "Select", then the address is entered.
• If you select the [Set as Default Value] option, the set value for a new address entry will be
displayed as the default value.
Device Bit Address Word Address 32bits Notes
Coil 00001 - 0001F 00001
*1
*1 Specify only the word address whose last digit is "1" .
Holding register - 40001 - 41544
• Holding register number 0900h is an address for the command (enter command) to write in
nonvolatile memory. By writing "1" in 0900h, writing to nonvolatile memory is enabled.
• You can only set the Read Area Size for the system area available to use in the External
Device. Please refer to the GP Pro-EX Reference Manual for Read Area Size.
Cf. GP Pro-EX Reference Manual "LS Area (Direct Access Method Area)"
• Refer to the precautions on manual notation for icons in the table.
)"Manual Symbols and Terminology"
1
2
To Next Page
Loading...
