Hitachi SJ200 Series

Inverter MODBUS RTU Driver
GP-Pro EX Device/PLC Connection Manual
43
6.4 SJ200 series
This address can be specified as system data area.
6.5 L200 series
This address can be specified as system data area.
Device Bit Address Word Address 32bits Notes
Coil 00000 - 0001F 00000 - 00010
Holding register - 40000 - 40900
• Holding register number 0900h is an address for the command (enter command) to write in
nonvolatile memory. By writing "1" in 0900h, writing to nonvolatile memory is enabled.
• You can only set the Read Area Size for the system area available to use in the External
Device. Please refer to the GP Pro-EX Reference Manual for Read Area Size.
Cf. GP Pro-EX Reference Manual "LS Area (Direct Access Method Area)"
• Refer to the precautions on manual notation for icons in the table.
)"Manual Symbols and Terminology"
Device Bit Address Word Address 32bits Notes
Coil 00000 - 0001F 00000 - 00010
Holding register - 40000 - 40900
• Holding register number 0900h is an address for the command (enter command) to write in
nonvolatile memory. By writing "1" in 0900h, writing to nonvolatile memory is enabled.
• You can only set the Read Area Size for the system area available to use in the External
Device. Please refer to the GP Pro-EX Reference Manual for Read Area Size.
Cf. GP Pro-EX Reference Manual "LS Area (Direct Access Method Area)"
• Refer to the precautions on manual notation for icons in the table.
)"Manual Symbols and Terminology"