Hitachi SJ200 Series

Inverter MODBUS RTU Driver
GP-Pro EX Device/PLC Connection Manual
42
6.2 SJ700 series
This address can be specified as system data area.
6.3 SJ700-2 series
This address can be specified as system data area.
Device Bit Address Word Address 32bits Notes
Coil 00001 - 0004E 00001 - 00031
*1
*1 Specify only the word address whose last digit is "1".
Holding register - 40001 - 43507
• Holding register number 0900h is an address for the command (enter command) to write in
nonvolatile memory. By writing "1" in 0900h, writing to nonvolatile memory is enabled.
• You can only set the Read Area Size for the system area available to use in the External
Device. Please refer to the GP Pro-EX Reference Manual for Read Area Size.
Cf. GP Pro-EX Reference Manual "LS Area (Direct Access Method Area)"
• Refer to the precautions on manual notation for icons in the table.
)"Manual Symbols and Terminology"
Device Bit Address Word Address 32bits Notes
Coil 00001 - 00052 00001 - 00041
*1
*1 Specify only the word address whose last digit is "1".
Holding register - 40001 - 43507
• Holding register number 0900h is an address for the command (enter command) to write in
nonvolatile memory. By writing "1" in 0900h, writing to nonvolatile memory is enabled.
• You can only set the Read Area Size for the system area available to use in the External
Device. Please refer to the GP Pro-EX Reference Manual for Read Area Size.
Cf. GP Pro-EX Reference Manual "LS Area (Direct Access Method Area)"
• Refer to the precautions on manual notation for icons in the table.
)"Manual Symbols and Terminology"