Configuring the New Disk Devices 3-3
Hitachi Universal Storage Platform V/VM Configuration Guide for SGI
®
IRIX
®
Host Attachment
# fx –x ← Start the fx utility.
fx version 6.5, Jul 11, 1999
fx: “device-name” = (dksc) Å Press Enter to label a disk.
fx: ctlr# = (0) 8 Å Enter the SCSI controller #.
fx: drive# = (1) 0 Å Enter the TID.
fx: lun# = (0) 15 Å Enter the LUN #.
...opening dksc(8,0,15)
...drive selftest...OK
Scsi drive type == Hitachi OPEN-3 5244
----- please choose one (? For help, .. to quit this menu)-----
[exi]t [d]ebug/ [l]abel/ [a]uto
[b]adblock/ [exe]rcise/ [r]epartition/
fx> r Å Enter r for partition menu.
----- partitions-----
part type blocks Megabytes (base+size)
0: xfs 266240 + 2048000 130 + 1000
1: xfs 2052096 + 2048000 1002 + 1000
8: volhdr 0 + 4096 0 + 2
10: volume 0 + 4806720 0 + 2347
capacity is 4806720 blocks
----- please choose one (? for help, .. to quit this menu)-----
[ro]otdrive [o]ptiondrive [e]xpert
[u]srrootdrive [re]size
fx/repartition> e Å Enter e for expert menu.
Warning: you will need to re-install all software and restore user data
from backups after changing the partition layout. Changing partitions
will cause all data on the drive to be lost. Be sure you have the drive
backed up if it contains any user data. Continue? y Å Enter y to continue.
Enter .. when done
Figure 3-1 Partitioning and Labeling the Disk Devices (without Fabric)
(continues on the next page)
To Next Page
Loading...
