Hitachi UX Twin Nozzle - Page 24

22
Holding Register data configuration (8/13)
Word
address
Classification Item name Setting range Contents
20 60
Count
condition
Zero-suppression 0 , 1
Sets the zero-suppression of the
count block 1.
0:Disable , 1:Enable
20 61 Multiplier(1st digit) 0x0020 to 0x0039
Sets the multiplier of the count
block 1.
Numeric:0x0031～0x0039
Decimal point:0x002E
Space:0x0020
… … …
20 6A Multiplier(10th digit) 0x0020 to 0x0039
20 6B Count skip(1st digit) 0x0020 to 0xFFFF
Sets the count skip of the count
block 1.
… … …
20 6F Count skip(5th digit) 0x0020 to 0xFFFF
20 70 Reserve_1
-
"Reserve" is not initially provided,
but may be added in future.
… …
20 73 Reserve_4
20 74
Count condition
(Count block 2)
-
Block 2 through 8 will be set in the
same configuration as those of
Block 1 (Address: from 0x1FE0 to
0x2073).
21 07
… …
23 EC
Count condition
(Count block 8)
24 7F
24 80
Adjust print
parameters
Calendar offset 0 , 1
Sets the calendar offset.
0:Offset from yesterday
1:From today
24 81 DIN print 0 , 1
Sets the DIN print.
0:Disable , 1:Enable
24 82 EAN Prefix 0 , 1
Sets the EAN prefix.
0:Edit message , 1:Print format
24 83 Barcode printing 0 , 1
Sets the barcode printing.
0:Normal , 1:Reverse
24 84 QR Error correction level 0 , 1
Sets the QR error correction level.
0:M (15%) , 1:Q (25%)
24 85 Reserve_1
-
"Reserve" is not initially provided,
but may be added in future.
… …
24 8F Reserve_11
24 90
On-line /
Off-line
On-line / Off-line 0 , 1
Change the on-line or off-line.
0:Offline , 1:Online
24 91 Reserve_1
-
"Reserve" is not initially provided,
but may be added in future.
… …
24 93 Reserve_3
24 94
Remote
operation
Remote operation 0 to 4
Specifies remote operation to IJP.
0:Operation start
1:Operation stop
2:Deflection voltage control (ON)
3:Deflection voltage control (OFF)
4:Fault clear
24 95 Reserve_1
-
"Reserve" is not initially provided,
but may be added in future.
… …
24 97 Reserve_3