17
PROGRAM SELECT(01)
Cycle Count:
Repeak Count: OFF
Trickle: OFF
Cut Volt: OFF
Cycle Mode
In Cycle Mode, users can choose
between charging>discharging or
discharging>charging. There are two
requirements for making the Cycle Mode
accessible: 1. The battery type must be NiMH
or NiCd and 2. The mode must be Cycle. This
mode is intended to help refresh your battery if
it has been sitting for a long period of time.
Cycle Count
In cycle mode, users must select the number of
cycles (between 1 and 5) for the Cycle Count.
Repeak Count
There are two requirements for accessing
Repeak Count: 1. The battery is either NiMH or
NiCd and 2. Users are in Re-Peak mode. There
are 3 Repeak Counts in total.
Trickle
When the Trickle function is activated, the
battery will continue charging, but at very low
current. This function is only available when
charging a NiMH or NiCd battery.
PROGRAM SELECT(01)
Cycle Count:
Repeak Count: OFF
Trickle: OFF
Cut Volt: OFF
O
Operating the Charger (continued)
The following functions are available when working with NiMH or
NiCd batteries:
PROGRAM SELECT(01)
Battery Cells: 5S
Mode: Cycle
C.Current 3.0A
D. Current -1.0A
PROGRAM SELECT(01)
Cycle Count:
Repeak Count: OFF
Trickle: OFF
Cut Volt: OFF
4
OFF
To Next Page
Loading...
