HITEC RDX1 PRO - Charging Your Battery; Pre-Operation Checks and Readiness; Starting the Charging Process; Information Displayed During Process

18
Charging Your Battery
Now that you have set all the parameters for your battery you are ready
to execute the operation. Now would be a good time to check to make
sure the charge settings are correct and within the battery manufacturers
recommendations.
BEFORE YOU BEGIN CHARGING YOUR BATTERY, MAKE SURE YOU
HAVE READ AND UNDERSTAND ALL OF THE WARNINGS AND SAFETY
INFORMATION CONTAINED ON PAGES 37.
DURING CHARGING/DISCHARGING, THE BATTERY SHOULD BE
PLACED INSIDE A FIRE PROOF/RETARDANT BAG AND ON A FIRE
PROOF SURFACE, AWAY FROM OTHER COMBUSTIBLE OBJECTS.
Start the Process
Press and hold the ► button until you see “BATTERY CHECK...”
followed by the con rmation screen. This screen displays the number of
cells you set up as “R” and the number of cells detected by the processor
as “S”. If both numbers are identical, you may press and hold the START
button to con rm and begin charging. If these numbers do not match,
press the STOP button to return to the previous screen and carefully check
the number of cells of the battery pack before proceeding.
Information Displayed During the Process
Use the INC. and DEC. buttons to scroll through the various information
displayed during the process.
Program Stop
During the charging process, press STOP to stop the process.
Program Complete
When the charging process is  nished, an audible sound will be heard.
Warning
Caution