EasyManua.ls Logo

HITEC RDX1 PRO - Prohibited Battery Types; Pre-Charging Checks and Guidelines

HITEC RDX1 PRO
28 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
5
A Never attempt to charge or discharge the following types of batteries:
A battery  tted with an integral charge circuit or a protection circuit
A battery pack which consists of di erent types of cells (including
di erent manufacturers cells)
A battery that is already fully charged or just slightly discharged and
non-rechargeable batteries (these pose an explosion hazard)
A faulty or damaged battery
Batteries installed in a device or which are electrically linked to other
components
Batteries that are not expressly stated by the manufacturer to be
suitable for the currents the charger delivers during the charge
process
PLEASE BEAR IN MIND THE FOLLOWING POINTS BEFORE YOU
COMMENCE CHARGING:
Did you select the appropriate program suitable for the type of battery you
are charging?
Did you set up the adequate current for charging or discharging?
Have you checked the battery voltage? Lithium battery packs can be wired
in parallel and in series, i.e. a 2-cell pack can be 3.7V (in parallel) or 7.4V (in
series).
Have you checked that all connections are  rm and secure?
Make sure there are no intermittent contacts at any point in the circuit.
Warnings and Safety Notes
This warning will  rst appear on the
screen prior to having full use of the
charger. Press ENTER to acknowledge
you have read and understood all
warnings before using this charger.
WARNING
NEVER LEAVE CHARGER
UNATTENDED. BATTERY CHARGING
CAN BE DANGEROUS. PRESS ENTER
TO CONFIRM YOU HAVE READ
THE MANUAL & WARNINGS AND
UNDERSTAND THEM.
Warning
IMPORTANT

Related product manuals