26 27
ERROR MESSAGE EXPLANATION
Error: DC Input Low! DC input voltage is lower than preset!
Error: DC Input High! DC input voltage is higher than preset!
Error: Battery Break! The battery may be damaged or discharged too low!
Cell Error The cells do not match.
Battery Type Error! The battery type is wrong!
Error: Overcharge! The battery is overcharged!
Error: Over Time! The program is timed out!
Error: Internal Temp. Too High! The internal temperature is high!
Error: Battery Temp. Too High! The battery temperature is high!
Error: Over Load! The charger is overloaded!
Error: Reversed Polarity The battery connection is reversed.
Error: Fully Charged The battery is fully charged already!
Error: Outlet Overload The output is overloaded.
Error: Balance Connection Break The balance connection is disconnected.
Error: Cell Volt Di. The voltage dierence between each cell is high.
Error: AC to DC Too Low! The input voltage is too low.
Error: Power Setting Error The DC power setting is incorrect.
STANDARDS TITLE
RE S ULT
EN 60335-1 Household and similar electrical appliances - Safety -Part 1: General requirements Conform
EN 60335-2-29
Household and similar electrical appliances – Safety – Part 2-29:
Particular requirements for battery chargers.
Conform
EN 55014-1
Electromagnetic compatibility – Requirements for household appliances, electric tools
and similar apparatus - Part 1: Emission
Conform
EN 55014-2
Electromagnetic compatibility – Requirements for household appliances, electric tools and
similar apparatus – Part 2: Immunity Product Family Standard
Conform
EN 61000-3-2
Electromagnetic compatibility (EMC) – Part 3-2: Limits for harmonic current emissions
(equipment input current up to and including 16 A per phase)
Conform
EN 61000-3-3
Electromagnetic compatibility (EMC) - Part 3-3: Limitation of voltage supply systems for
equipment with rated current ≤ 16 A.
Conform
FCC Part
Subpart 15B
Title 47 Telecommunication | PART 15 - RADIO FREQUENCY DEVICES
Subpart B - Unintentional Radiators
Conform
In the event of a fault, the charger will display an error message and sound an alarm.
The RDX2 200 satisfies all relevant and mandatory CE directives and FCC Part 15 Subpart B.
To recover from a firmware upgrade failure, please follow these steps:
1. Hold the STOP and ENTER buttons simultaneously, then connect the power cord;
the RDX2 200 will power on with a blue screen notice.
2. Connect the RDX2 200 to your computer via a Type-C USB cable.
3. Launch the Charge Manager on your PC or Mac.
4. When the status shows CONNECTED, click to check for new firmware.
5. Click to upgrade after detecting a new firmware.
6. Wait for the progress bar to finish and reach 100%.
WARNING & ERROR MESSAGES FIRMWARE UPDATE NOTICE
DECLARATION OF CONFORMITY
NOTE
THE PROCESS WILL TAKE ABOUT 5 MINUTES. FIRMWARE CAN ALSO
BE UPDATED THROUGH THE LINKPOWER X MOBILE APP.
To Next Page
