OM 2012
r
Freezi~.;a Pi>inf
Percentogr-: of anfiirr:cze
(FcxCd~eii)
in so!ution
------
-
-:-2(p
16%
4-I CO
25%
O0
33- ?/3%
-10”
4036
-20”
45%
-30°
50% I
-400
54%
-500
58%
-6OO
62%
-700
65%
_.
Antifreeze Solution Table
Figure IO
(4) Antifreeze solution installation
.
Before installing antifreeze in the system, make the foI!owing checks:
l
. (a> Check the system for signs.of leaks.
(b) Inspect a! I hoses and tighten a! I hose clamps.
Install new hoses if ’
necessary.
(c) Drain and clean the system. Ref. Parcr. 7, E and 7, F.
(d) Check the condition and tension of the fan and water pump belts and
alternator beIts. Replace the belts if necessary.
(e). Be sure radiator and engine drain.valves (Ref. Fig. 11) are closed,
and al! connections are securely tightened.
(f) J&a! I the required amount of antifreeze (Ref. Fig. 10). Fi!f the
system with coolant as out! ined under Para. 7, H.
E. Drain the Cooling System
Drain the cooling system immediately after stopping the engine, while most of the
sediment is in suspension. Proceed as follows: .
(7) Remove radiator cap.
Aug 25185
2-l
Page 15
To Next Page
Loading...
