23 of 32
Removal of All Zones from a Start
Á A START will not allow
you to turn it ON until
a ZONE is selected
for the START
® If any active (ON) START/S
have all ZONES deselected
and turned off, you will
need to add a ZONE back
to restore the START
1. To restore the ZONE/S, turn
the MENU DIAL to select
the START NUMBER
2. Press the MENU DIAL
3. A box will flash around
START TIME
4. Turn the dial anti‑clockwise
(left) until you enter
ZONE selection, a
box will flash around
ZONE—refer to step 5 in
ZONE setup instructions
to continue to
restore ZONES
Setup (continued)
To Next Page
Loading...
