Homematic IP HmIP-FALMOT-C12 User Manual

53
Start-up
If you want to pair the floor heating actuator with a
Homematic IP Wall Thermostat, the pairing mode of both
devices has to be activated first. To do this, proceed as
follows:
• Select the channel to which you would like to pair
a device by pressing the channel button (D) brief-
ly (see figure 7). Press once for channel 1, press
twice for channel 2, etc. The channel is question
is shown in the display (B).
• Press and hold down the system button (A) for
4 seconds until the LED quickly starts flashing
orange (see figure 6). The pairing mode of the
selected channel remains activated for 3 minutes.
• Press and hold down the system button of the
wall thermostat for at least 4 seconds to activate
the pairing mode. The device LED flashes orange.
The device LED (A) lights up green to indicate that pairing
has been successful. If pairing failed, the device LED (A)
lights up red. Please try again.
6.4.2 Pairing with a Homematic IP Multi IO Box
If you want to pair the floor heating actuator with a
Homematic IP Multi IO Box, the pairing mode of both
devices has to be activated first. To do this, proceed as
follows:
• Keep pressing the channel button (D) briefly un-
til all channels are shown in the display (B) (see

Homematic IP HmIP-FALMOT-C12 Specifications

General

Input voltage	24/230 V
Input frequency	50 Hz
Power source type	AC, DC
Maximum switching capacity	0.2 W
Frequency	869.65 MHz
Cable length	1.5 m
Display type	LCD
Product type	Heating actuator
Product color	White
Built-in display	Yes
Channels quantity	12 channels
Maximum outdoor range	320 m
International Protection (IP) code	IP20
Operating temperature (T-T)	0 - 50 °C

Weight and Dimensions

Depth	52 mm
Width	242 mm
Height	85 mm
Weight	440 g
Package depth	281 mm
Package width	184 mm
Package height	97 mm
Package weight	917 g