81
SERVICING YOUR OUTBOARD MOTOR
11. Position the aligning mark as
shown in the figure when
installing the suspension strap on
the water separator.
12. The drain joint should be
positioned within the protruded
portion of the suspension strap as
shown in the figure.
13. Prime the engine using the
priming bulb (p.39). Check for
fuel leaks. Repair any fuel leaks if
necessary.
If the buzzer sounds or water or
sediment accumulation is found in the
fuel filter, inspect the fuel tank.
Clean the fuel tank and tank filter if
necessary. It may be necessary to
drain the fuel tank completely and
refill with fresh gasoline.
WATER SEPARATOR
ALIGNING
MARK
SUSPENSION
STRAP
SUSPENSION STRAP
PROTRUDED PORTION
DRAIN JOINT
31ZX26040.book Page 81 Friday, July 25, 2014 5:14 PM
To Next Page
Loading...
