Honeywell 013080 - 9 Automatic; 10 Maintenance; Remote Parameterisation

9. Automatic
10. Maintenance
Select the button Automatic. A macro or automatic function can combine several individual
functions and thus also contain extensive function or control sequences.The operating menu
shows executable macros / automatic functions. The selected macro or automatic function is
started with the "Start" key (only start possible with the MB-Secure panel).The "Lock" key locks
the selected macro, i.e. the automatic function no longer runs.
Select the Maintenance button.
The operating menu is used to display the next maintenance date of the panel and to display
information about the TouchScreen ControlPanel and the panel.
The operating menu is also used to enable remote parameterisation, i.e. remote access to the
panel by the installer.
10.1 Remote parameterisation
The type of remote parameterisation release depends on the programming of the panel. If a permanent
release is programmed on the panel, the button Remote papametrisation Disabeled is replaced by the è
label Permanent release.è
Press Button for
Release
Manual release:
Press Button for
disable the parametrisation
Button change
Remote parametrisation
Disabled
Remote parametrisation
Disabled
Remote parametrisation
Enabled
Button change
13
Operating Instructions MB TouchScreen ControlPanel