Why does my Honeywell Barcode Reader have multiple scans when presenting a code?
If there are multiple scans upon presentation of a code with your Honeywell Barcode Reader, the same symbol timeout is likely set too short. Adjust the same symbol timeout for a longer time increment.
Why does my Honeywell 7120 Orbit scan the barcode but show no data?
If your Honeywell Barcode Reader scans the bar code but shows no data, the unit may not be configured correctly. Make sure the scanner is configured for the appropriate mode.
Why are characters being dropped by my Honeywell 7120 Orbit Barcode Reader?
If characters are being dropped by your Honeywell Barcode Reader, the inter character delay needs to be added to the transmitted output. Add some inter-character delay to the transmitted output by using the MetroSelect Configuration Guide (PN 00-02407).
General| Brand | Honeywell |
|---|---|
| Model | 7120 Orbit |
| Category | Barcode Reader |
| Language | English |
Instructions for installing the scanner using RS232 or Light Pen emulation interfaces.
Instructions for installing the scanner using the RS485 interface.
Instructions for installing the scanner using the Keyboard Wedge interface.
Instructions for installing the scanner using the Stand-Alone Keyboard interface.
Instructions for installing the scanner using the Full Speed USB interface.
Details specific LED and beep patterns that indicate scanner malfunctions and required actions.
Provides crucial safety warnings regarding laser exposure and handling of the scanner.
Provides contact methods for obtaining technical support, including knowledge base and portal.
Outlines the process for obtaining warranty or non-warranty service and repair for the product.
To Next Page