Honeywell Accenta User Manual

Accenta/Optima User Guide
7
LED Keypad:
• Enter your [4-digit code] to start the exit procedure (for
more information see How to Set the System).
• Press [OMIT] and the exit beep tone will stop, and all
LED’s for used zones that can be omitted will come on.
• Press the zone [number] to be omitted. The LED will now
flash to show the zone as omitted. If a flat reject tone is
heard, then the zone cannot be omitted.
• Press [SET] or allow the system to set.
[4-digit code]
[OMIT]
Power
Attack
Tamper
Day
Zones
1
23
4567
8
[Number]
Power
Attack
Tamper
Day
Zones
1
23
4567
8
[SET]
How to Quick Set the System
When you set the system you will usually have about 30 seconds to exit the premises. This also means that
you need to wait 30 seconds for the system to set. You can reduce this time to just five seconds by carrying
out a Quick Set.
• Enter your [4-digit code] to start the exit procedure. The exit beep tone will start. (For more
information see How to Set the System).
• Press [SET] to Quick Set the system and the exit beep tone will change to a more rapid tone. The
system will set in five seconds, and the exit tone will stop.
Single Key Setting
If enabled by the engineer, the setting process can be started by pressing Set, rather than entering a user code.
How to Quick Set
Power
Attack
Tamper
Day
Zones
1
23
4567
8

Honeywell Accenta Specifications

General

Tamper Circuit	Yes
Event Log	Yes
Battery Backup	Yes
Keypad	Wired
Power Supply	230V AC, 12V DC