EasyManuals Logo

Honeywell Accenta User Manual

Honeywell Accenta
24 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #6 background imageLoading...
Page #6 background image
Accenta/Optima User Guide
2
LCD Keypad:
Enter your 4-digit code (0123 default) and check that the system
is clear.
The exit tone begins to sound and the display shows program 1 in
process of setting.
Leave the premises by the agreed exit route.
The exit tone becomes rapid during the last 10 seconds and
then stops when the system sets. The Day LED goes off and
SYSTEM SET appears on the screen
After 30 seconds the set mode display appears.
LED Keypad:
The system is unset. The Power and Day LED’s are on.
Enter your 4-digit code (0123 default) and check that the
system is clear (no zone LED’s on).
The exit tone begins to sound to indicate that the system is
in the process of setting.
Leave the premises by the agreed exit route.
The exit tone becomes rapid during the last 10 seconds and
then stops when the system sets. The Day LED goes off.
How to Set the System
How to Set the System
When you leave your premises you will need to set (or turn on) the intruder alarm system.
Before setting the system you should ensure that the premises have been completely vacated and that all
doors and windows are closed. Ensure that pets do not have access to the protected areas as they can
cause a false alarm.
NOTE: The Accenta Remote LED keypad is not shown. It will have the same indications as the Optima
compact panel with built-in keypad.
NOTE: There will be no exit beeps if Silent Timed exit mode was programmed.
LCD Keypad: the Day LED should be on. The screen shows the day mode:
LED Keypad: the Day LED should be on.
Enter Your CodeEnter Your Code
Enter Your CodeEnter Your Code
Enter Your Code
********
********
****
[4-digit code]
Program 1 SetProgram 1 Set
Program 1 SetProgram 1 Set
Program 1 Set
** SYSTEM SET **** SYSTEM SET **
** SYSTEM SET **** SYSTEM SET **
** SYSTEM SET **
SundaySunday
SundaySunday
Sunday
01-Jan01-Jan
01-Jan01-Jan
01-Jan
14:10 14:10
14:10 14:10
14:10
TA
PA
Day
Power
[4-digit code]
NOTE: You should wait until you hear that the exit beep has stopped before assuming that the system has
set.
Power
Attack
Tamper
Day
Zones
1
23
4567
8
Power Day
Sunday 01-Jan
14:10

Other manuals for Honeywell Accenta

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Honeywell Accenta and is the answer not in the manual?

Honeywell Accenta Specifications

General IconGeneral
Tamper CircuitYes
Event LogYes
Battery BackupYes
KeypadWired
Power Supply230V AC, 12V DC

Related product manuals