Honeywell Accenta User Manual

Accenta/Optima User Guide
17
How to do a Walk Test
Walk around your property, and in turn cause each detector to go into alarm. Also, open and close all door
and windows that are protected by the system. For each detector (including door or window sensor) that is
activated the system will produce a series of beeps, and the associated zone will be indicated on the keypad.
NOTE: Do not test any Personal Attack, Fire or Tamper buttons during the Walk Test since these are still
active and will cause a full alarm.
If any of the tests fail, or you are unsure of the correct procedure, contact your installer
LCD Keypad:
• Press [PROG] and then enter your code [0][1][2][3]. The
Day LED goes off to indicate that you are in Programming
mode. The first menu Walk Test appears on the screen.
• Press [SET] or [0]. Zones 1-8 have a zero (0)
below each number.
• When a zone is successfully tested, number 1
replaces the 0. Zones are added to list as each
one is activated.
• Press [RESET] to leave the menu or [SET] to
restart the Walk Test.
LED keypad
• Press [PROG] and then enter your code [0][1][2][3]. The
Day LED goes off and the Tamper (TA) LED comes on to
indicate that you are in Programming mode, Walk Test
• Press [SET] or [0]. Zones 1-8 are off.
• When a zone is sucsessfully tested, the LED is on.
Zones are added to list as each one is activated.
• Press [RESET] to leave the menu or [SET] to restart the
Walk Test.
How to do a Walk Test
[PROG] then [0][1][2][3]
0>Walk Test0>Walk Test
0>Walk Test0>Walk Test
0>Walk Test
[SET] or [0]
[RESET]
0>Walk Test0>Walk Test
0>Walk Test0>Walk Test
0>Walk Test
12345678 TP12345678 TP
12345678 TP12345678 TP
12345678 TP
00000000 0000000000 00
00000000 0000000000 00
00000000 00
12
3
4
5
6
7
8
[SET]
12
3
4
5
6
7
8
[RESET]
[PROG] then [0][1][2][3]
Power
Attack
Tamper
Day
Zones
1
23
4567
8

Honeywell Accenta Specifications

General

Tamper Circuit	Yes
Event Log	Yes
Battery Backup	Yes
Keypad	Wired
Power Supply	230V AC, 12V DC