Accenta/Optima User Guide
10
Changing Codes Using User 2
Your alarm system can have a second user code. You may find it useful to set up user code 2 for use by a
neighbour for use when you are on holiday. User code 2 operates like user code 1, but it cannot be used to
change or delete user code 1.
To change user code 2:
LCD Keypad:
• Press [PROG] and then enter user 2 [four-digit code]. The
Day LED goes off to indicate that you are in Programming
mode. The first menu Walk Test appears on the screen.
• Press [8] to edit user 2.
• Enter the new [4-digit code]. If the code is accepted the
system will produce a double beep. If it is rejected the code
may already be in use and the system will produce a flat tone.
You must choose a different 4-digit code.
• Upon the last keypress the code is saved.
• Press [RESET] twice to exit Programming mode. The Day
LED will come on with the screen in Day mode.
LED Keypad:
• Press [PROG] and then enter user 2 [four-digit code]. The
Tamper (TA) LED comes on and the Day LED goes off to
indicate that you are in Programming mode.
• Press the [8] to edit user 2. LED’s 1-4 are on.
• Enter the new [4-digit code]. If the code is accepted the
system will produce a double beep. If it is rejected the code
may already be in use and the system will produce a flat tone.
You must choose a different 4-digit code.
• Upon the last keypress the code is saved. LED’s 1-4 are off.
• Press [RESET] twice to exit Programming mode. The Day
LED comes on and the Tamper (TA) goes off.
[8]
0>Walk Test0>Walk Test
0>Walk Test0>Walk Test
0>Walk Test
[PROG] then [4-digit code]
Edit CodeEdit Code
Edit CodeEdit Code
Edit Code
--------
--------
----
Code SavedCode Saved
Code SavedCode Saved
Code Saved
[4-digit code]
[RESET]
SundaySunday
SundaySunday
Sunday
01-Jan01-Jan
01-Jan01-Jan
01-Jan
14:10 14:10
14:10 14:10
14:10
[PROG] then [4-digit code]
Power
Attack
Tamper
Day
Zones
1
23
4567
8
[8]
[4-digit code]
To Next Page
Loading...
Need help?
General
