Accenta/Optima User Guide
9
Changing Codes Using User 1
You should change your code regularly to prevent potential intruders from knowing your code. All codes are
4-digits. The factory set code is [0][1][2][3]. User code 1 can only be changed by user 1.
To change user code:
LCD Keypad:
• Press [PROG] and then enter your code [0][1][2][3]. The
Day LED goes off to indicate that you are in Programming
mode. The first menu Walk Test appears on the screen.
• Press the [8] button on the keypad to enter User Set-Up.
• Press the [1] or [2] button on the keypad to
edit the required user.
• Enter the new [4-digit code]. If the code is accepted the
system will produce a double beep. If it is rejected the code
may already be in use and the system will produce a flat tone.
You must choose a different 4-digit code.
• Upon the last keypress the code is saved.
• Press [RESET] twice to exit Programming mode. The Day
LED will come on with the screen in Day mode.
LED Keypad:
• Press [PROG] and then enter your code [0][1][2][3]. The
Tamper (TA) LED comes on and the Day LED goes off to
indicate that you are in Programming mode.
• Press the [8] button on the keypad. LED’s 1 and 2 are on to
indicate that you have two options, user 1 and user 2.
• Press the [1] or [2] button on the keypad to
edit the required user. LED’s 1-4 are on.
• Enter the new [4-digit code]. If the code is accepted the
system will produce a double beep. If it is rejected the code
may already be in use and the system will produce a flat tone.
You must choose a different 4-digit code.
• Upon the last keypress the code is saved. LED’s 1-4 are off.
• Press [RESET] twice to exit Programming mode. The Day
LED comes on and the Tamper (TA) goes off.
Edit CodeEdit Code
Edit CodeEdit Code
Edit Code
--------
--------
----
Code SavedCode Saved
Code SavedCode Saved
Code Saved
[1] or [2]
[4-digit code]
[RESET]
SundaySunday
SundaySunday
Sunday
01-Jan01-Jan
01-Jan01-Jan
01-Jan
14:10 14:10
14:10 14:10
14:10
How to Change User Codes
[PROG] then [0][1][2][3]
Power
Attack
Tamper
Day
Zones
1
23
4567
8
Power
Attack
Tamper
Day
Zones
1
23
4567
8
[8]
[1] or [2] then [4-digit code]
Power
Attack
Tamper
Day
Zones
1
23
4567
8
[RESET]
Power
Attack
Tamper
Day
Zones
1
23
4567
8
8>Set Up8>Set Up
8>Set Up8>Set Up
8>Set Up
User [Number]User [Number]
User [Number]User [Number]
User [Number]
[8]
0>Walk Test0>Walk Test
0>Walk Test0>Walk Test
0>Walk Test
[PROG] then [0][1][2][3]
To Next Page
Loading...
Need help?
General
