To Next Page

To Previous Page

Accenta/Optima User Guide

How to Part Set the System

If your installer has programmed your system for part set operation you will be able to set some zones of the

system while others remain unset. Part set operation is often used at night time, and it will permit you to freely

walk around the bedrooms while the living area and outside doors are protected. Your system may have 2

part-set programs called Program 2 and Program 3.

Before part-setting the system you should ensure that all doors and windows are closed. Ensure that pets do

not have access to the protected areas. Your installer may have instructed you to use a different keypad to the

one normally used to set the system.

LCD Keypad:

• The Day LED should be on. The screen shows the Day

mode:

• Enter your code [0][1][2][3]. The exit beep starts.

• Press the [PROG] key. The exit tone stops.

• Select part-set program [2] or [3]. The system will set after a

short time. The Day LED goes out.

NOTE: There will be no exit beeps if Silent Timed exit mode was

programmed.

How to Part Set

[4-digit code]

** SYSTEM SET **** SYSTEM SET **

** SYSTEM SET **

SundaySunday

Sunday

01-Jan01-Jan

01-Jan

14:10 14:10

14:10

Program 1 SetProgram 1 Set

Program 1 Set

Set SystemSet System

Set System

Select 1 2 or 3Select 1 2 or 3

Select 1 2 or 3

[PROG]

[2 or 3]

Power Day

Sunday 01-Jan

14:10

Honeywell Accenta User Manual

Other manuals for Honeywell Accenta