CT30 XP Mobile Computer User Guide 11
• For maximum battery life, charge the battery at 20 °C (68 °F) to 25 °C (77 °F)
and store at 25 °C (77 °F) with a 30% charge.
• Do not store the battery pack at temperatures above 45 °C (113 °F). Storage
above 45 °C (113 °F) may damage the battery pack.
• Charge the battery before use. Battery ships with only a partial charge.
• See Charge the Battery Before Use on page 5 for approved charging methods.
Use of this battery in other devices could result in damage to the device or
battery.
• Avoid dropping the battery or computer. If you suspect that the battery or
computer is damaged, send it to Honeywell service center for inspection.
• Replace the battery only with another CT30P-BTSC model battery that matches
the part number noted in the Battery Part Numbers (see page 5) section of this
guide. These batteries have been tested in accordance with applicable safety
standards. Contact your Honeywell sales representative or distributor if this
battery is no longer available.
• Discarded batteries may create a safety hazard. Before disposal, cover the
battery contacts with electrical insulating tape.
• Do not modify the battery or attempt to insert foreign objects into it.
• Do not solder directly to the battery contacts.
• Do not drop the battery or apply mechanical shocks or pressure to it.
• Do not immerse batteries into, or expose them to, water or seawater.
• Do not incinerate, microwave, throw into a fire, or expose batteries to
temperatures above the maximum rating.
• Do not disassemble a battery or try to open or penetrate its housing.
Power On the Computer
After you have fully charged and installed a battery, power on the computer for the
first time:
•Press and hold the Power button for approximately 3 seconds, and then release
the button.
Welcome Screen
The first time you power on the computer, a Welcome screen appears. You can
either scan a configuration barcode or use the Wizard to manually set up the
computer. To learn more about how to Scan Barcodes, see page 43. To learn more
about configuring multiple devices using Wi-Fi Staging, see page 90.
During the manual setup process, follow the prompts on the screen as the wizard
has you:
• Set the default language.
To Next Page
Loading...
