CT30 XP Mobile Computer Series User Guide 57
Mobile computers are enrolled by scanning a QR code. Contact your mobile carrier
to obtain the QR code and any other information required to activate the profile.
Select the eSIM
In the SIM Selection app, the nano-SIM card (SIM 1) is selected by default. To use
the embedded SIM without being in Dual SIM Dual Standby mode, you must select
SIM 2 as the active SIM.
1. Swipe up from the bottom of the Home screen to access all apps.
2. Tap SIM Selection .
3. Under Select New Configs, tap the arrow next to SIM Slot 1.
4. Select “SIM 2” from the drop-down list.
5. Click APPLY.
6. A prompt verifies that you want to apply the new configuration. Tap OK.
7. The system indicates that the settings have been saved. Tap OK.
Download a Profile
The mobile computer must be connected to a Wi-Fi network to download the
profile. See Network & Internet settings for more information.
1. Swipe up from the bottom of the Home screen to access all apps.
2. Tap the Thales LPA app.
3. On the home screen, tap the plus sign.
4. Tap the QR code icon.
5. Scan the QR code.
6. The Activation Code value is displayed. Click NEXT.
7. If the profile is configured to require additional input, enter the information
provided by your mobile carrier.
8. When the profile has downloaded, it will be listed on the app home screen. Tap
the slider to enable the profile.
Provision Dual SIM Dual Standby
The CT30 XP allows you to enable a Dual SIM Dual Standby (DSDS) setup where
both SIMs are provisioned with separate mobile plans. In DSDS, only one SIM card
can handle data at a time.
To enable Dual SIM Dual Standby mode, you first turn DSDS on then provision the
nano-SIM card and eSIM.
To Next Page
Loading...
