Chapter 7. PARAMETER SETUP
7-32
No. Item Code Item Factory User Setting
Setting Setting
82 C 8 2 0
83
C 8 3 —
84
C 8 4 0
85 C 8 5 0
86 C 8 6 —
87 C 8 7 —
88 C 8 8 —
89 C 8 q —
90 C q 0 0
91
C q 1
—
92 C q 2 —
93 C q 3 0
94 C q 4 0
95 C q 5 —
96 C q 6 —
97 C q 7 —
98 C q 8 —
99 C q q —
100 C 0 0 —
0: Expansion disabled
1: Expansion enabled
[Note]
This setting is for service use only.
[Note]
“– – – –” is displayed and setting is not possible.
0 to 127
[Note]
On models not supporting communications, “– – – –” is
displayed and setting is not possible.
0 disables communication.
0: 9600bps/even parity, 1 stop bit
1: 9600bps/no parity, 2 stop bits
2: 4800bps/even parity, 1 stop bit
3: 4800bps/no parity, 2 stop bits
[Note]
On models not supporting communications, “– – – –” is
displayed and setting is not possible.
[Note]
“– – – –” is displayed and setting is not possible.
[Note]
Normally set to “0”.
[Note]
“– – – –” is displayed and setting is not possible.
[Note]
“– – – –” is displayed and setting is not possible.
0: Add-on terminal
1 to 15: Loader jack (communications address)
0: Improved
1: Compatible with DCP200
[Note]
“– – – –” is displayed and setting is not possible.
[Note]
This setting is for service use only, and can only be
verified.
Expansion setting 2
Unused
Station address
Transmission rate/
character format
Unused
Unused
Unused
Unused
Special functions
Input 1 zener barrier
adjustment
Unused
CPL communica-
tions port selection
PID type
Unused
Hardware type 1
Hardware type 2
ROM ID
ROM item
ROM revision
To Next Page
Loading...
