Honeywell DCP301 - Display in constant-value operation mode

Chapter 6. OPERATION
6-5
● Display 7
SP
TM
SP
Time
Program No. Segment No.
Pattern
tendency
Output states of events 1 to 3, time events 1 to 5
The digit to which SP values can be entered blinks in the MANUAL mode when pro-
grammer functions are selected. Either of “h:min” or “min:s” is selected as the time unit
in setup settings. Select either “remaining segment time” or “total operating time” in
setup settings as the details whose time is to be displayed.
■ Display in constant-value operation mode
●
DISP
functions
Output Model No. Display
0D, 5G, 6D Display 1 → Display 2 → Display 1 (repeated)
2G Display 1 → Display 2 → Display 3 → Display 1 (repeated)
3D, 5K Display 1 → Display 2 → Display 4 → Display 1 (repeated)
● Display 1
PV
SP
PV
SP
Output state of events 1 to 3
The digit to which SP values can be entered blinks in the MANUAL mode when control-
ler functions are selected.
● Display 2
PV
OUT
PV
Output value (%)
Output state of events 1 to 3
The digit to which SP values can be entered blinks in the MANUAL mode when pro-
grammer functions are selected.