Honeywell DCP301 - Display in program operation mode

Chapter 6. OPERATION
6-3
■ Display in program operation mode
●
DISP
functions
Output Model No. Display
0D, 5G, 6D Display 1 → Display 2 → Display 5 → Display 6 → Display 7 →
Display 1 (repeated)
2G Display 1 → Display 2 → Display 3 → Display 5 → Display 6 →
Display 7 → Display 1 (repeated)
3D, 5K Display 1 → Display 2 → Display 4 → Display 5 → Display 6 →
Display 7 → Display 1 (repeated)
● Display 1
PV
SP
PV
SP
Program No. Segment No.
Pattern
tendency
Output states of events 1 to 3, time events 1 to 5
The digit to which SP values can be entered blinks in the MANUAL mode when pro-
grammer functions are selected.
● Display 2
PV
OUT
PV
Output value (%)
Program No. Segment No.
Pattern
tendency
Output states of events 1 to 3, time events 1 to 5
The digit to which SP values can be entered blinks in the MANUAL mode when control-
ler functions are selected.
● Display 3
Program No. Segment No.
Pattern
tendency
Motor valve opening (%)
Output states of events 1 to 3, time events 1 to 5
F B
This display is exclusive to 2G output models (output catalog No. appended with 2G).