Honeywell DCP301 - Page 77

Chapter 6. OPERATION
6-4
● Display 4
OUT
Heat-side output (%)
Cool-side output (%)
Program No. Segment No.
Pattern
tendency
Output states of events 1 to 3, time events 1 to 5
This display is exclusive to heat/cool output models (output catalog No. appended with
3D or 5K).
● Display 5
PV
TM
PV
Time
Program No. Segment No.
Pattern
tendency
Output states of events 1 to 3, time events 1 to 5
Either of “h:min” or “min:s” is selected as the time unit in setup settings. Select either
“remaining segment time” or “total operating time” in setup settings as the details whose
time is to be displayed.
● Display 6
PV
CYC
PV
Number of remaining cycles
Program No. Segment No.
Pattern
tendency
Output states of events 1 to 3, time events 1 to 5
When the remaining number of cycles is “0”, subsequent cycle operation is not carried
out.