Honeywell Dolphin 99EXLF User Manual

11 - 5
Bottom Panel
For details on how to mount the HomeBase, see Mounting the HomeBase on page 11-9.
Power
The base requires 12 Volts DC input for communications, battery charging, and power output to the ter-
minal; the power adapter included with the base converts the voltage from the AC power source to
12 Volts DC. Use only UL listed power supply, which has been qualified by Honeywell, with output rated
at 12VDC and 3 amps with the device. The operating temperature range is -10° to 50°C (14° to 122°F).
Honeywell recommends that you leave the base connected to its power source at all times, so that it is
always ready to use.
We recommend use of Honeywell peripherals, power cables, and power adapters. Use of any non-Honeywell
peripherals, cables, or power adapters may cause damage not covered by the warranty.
Connecting Power to the HomeBase
1. Plug the A/C power cord into the power adapter.
2. Plug the power cable into the power connector on the back of the HomeBase.
3. Plug the A/C power cord into a grounded power source. The base is now powered. The Power/Dock
LED on the HomeBase illuminates solid red to indicate the HomeBase has power and no terminal is
docked.
Compliance Label
Serial Number Label
!
Power Cable
A/C Power Cord
Power
Adapter

Honeywell Dolphin 99EXLF Specifications

General

Brand	Honeywell
Model	Dolphin 99EXLF
Category	PDA
Language	English