E
3
Point Gas Monitor Technical Manual
17
Monitor Operation
Monitor Operation
Using the Programming Menus
The programming menus provide a series of options that let you
customize your gas detection system. Press the enter key to access the
programming menus. If no buttons are pressed for 2 minutes, the monitor
exits programming mode to normal operation.
CAUTION: Only qualified, knowledgeable personnel should use the
programming functions of this monitor. Factory settings conform to specific
standards. See Specifications. Any changes made to Alarm Levels may
affect manufacturer’s stated standards compliance.
Main Menu Options
Each menu option provides access to further sub-menus. Consult the
following pages of this manual for menu use instructions.
Menu options do not apply to Remote model
Menu
Options
Description
Menu Type
Password
Protects programming menus from
unauthorized access.
Shared menu
Network
Defines device address, baud rate, BACnet
ID, or communication protocol (Network
Model only).
Model specific menu
*only for Network model
Display Provides a choice of discrete display. Shared menu
Relay
Defines whether the relays will be latched,
failsafe or activated.
Model specific menu
Buzzer
Provides a choice between activated or
silenced.
Model specific menu
Alarm Allows configuration of various alarm levels . Model specific menu
Temp Sets the maximum temperature level. Shared menu
Restore
Restores the device’s factory configured
calibration settings.
Shared menu
SetZero Sets the sensor zero. Shared menu
SetSpan Calibrates the sensor span. Shared menu
w ww . . co m
information@itm.com1.800.561.8187
To Next Page
Loading...
