Honeywell E3Point E3DA User Manual

E
3
Point Gas Monitor Technical Manual iii
IMPORTANT NOTICE
IMPORTANT NOTICE
System Validation Test or Commissioning of the gas detection system is
not complete until it is tested to verify that it is functioning according to
its design objectives or specifications.
Validation includes, but is not limited to:
• Verication tests of the functions of each component in the individual
system architecture.
• Verication that all inputs to the system result in the correct outputs.
• Verication that, where required, a back-up power supply system
is in place.
• Verication that all personnel who will be working with and/or
affected by the system have received proper instruction on use
and purpose.
w ww . . co m
information@itm.com1.800.561.8187

Honeywell E3Point E3DA Specifications

General

Model	E3Point E3DA
Operating Temperature	-20°C to 50°C (-4°F to 122°F)
Display	LCD with backlight
Detection Method	Electrochemical
Gases Detected	Oxygen, Carbon Monoxide
Power Supply	24 VDC / VAC
Output	4-20 mA, Modbus RTU
Alarms	Visual and Audible
Enclosure	IP66
Certifications	UL, CSA, CE
Relays	3 relays