Galaxy 3 Series Programming Manual
19
NOTES:
1. Where two identical events occur within 1 second, only one is logged.
2. Only the first occurrences of high resistance and low resistance events on each day are logged.
Subsequent activations are ignored until midnight of the same day. This is to prevent the log
from being filled with high and low resistance activations from a faulty zone.
The event log can be printed while accessing the Display Log option. Pressing the
key while displaying an
event starts the printout from the displayed event and prints forward to the most recent event. The esc key
aborts the print out.
NOTE: A serial printer must be connected to the Galaxy panel via a printer interface module, the RS232
interface module, or the RS232 serial port.
Option 23 – System
This option provides a quick overview of the system configuration; two lines of information are displayed at a
time - the A and B keys are used to scroll through the entire list:
• Groups use the A and B keys to scroll through groups A1–8, B1–8, C1–8 and D1–8
• Group status U = Unset, S = Set, P = Part set and L = Locked-out for each of the groups
displayed;
NOTE: Enabling the Show Status option (refer to option 58 = KEYPADS) allows the group set status to
be displayed from the normal banner (when the system is set or unset) by pressing the and # keys
simultaneously.
• Type Galaxy 48, 144 or 520;
• Version version of software in Galaxy panel;
• RIOs fitted includes the on-board RIOs;
• Codes used includes the manager, engineer and remote codes;
• Keypads fitted 1–8 (Galaxy 48), 1–16 (Galaxy 144), 1–32 (Galaxy 520);
• Comms modules 1-6 (Telecom, RS232, ISDN, Ethernet, on-board Telecom, on-board RS232 port);
• Printer 0–1 (Printer Interface Module);
• Max Modules gives the number of MAX/MicroMAX/MAX
3
modules on the system;
• Panel location up to 16 characters of text entered in System Text parameter (option 51.15.2).
23 - System
To Next Page
Loading...
Need help?
General
