Galaxy 3 Series Programming Manual
40
45 - Timer Control
Option 45 – Timer Control
1 = View
This option allows the programmed times in each of the Timers to be viewed:
1. Timer A;
2. Timer B;
3. Autoset
Use the A and B keys to scroll through each of the programmed times.
NOTE: The programmed times cannot be modified using this option.
All of the programmed timers - Timer A, Timer B, Autoset - can be printed out using option 57.11 =
SYSTEM PRINT.Timers.
2 = Holidays
This function allows up to ten holiday periods to be allocated. A Start and End date is entered for each
holiday period using the 1 = Modify Dates option, and the groups that are affected by the programmed
holiday periods are assigned using the 2 = Assign Groups function. The operation of all timers for the as-
signed groups is suspended during these dates; the last operation of the Timers before the start date remains
in operation until the first operation after the end date. For example, a code which has been allocated the
Timer A period in the CODES option (42.1.4.1) will be inoperative during the programmed holiday period if
the Timer A is in the On time when the holidays starts.
1 = Modify Dates
On selecting this option, the Start and End dates for holiday period 1 are displayed; an arrow (>) points to
the Start date. If no dates have been entered for this period, then the display shows /. To program
the Start date, press the ent key; the date display changes to >DD/MM<; enter a valid four digit number
and press the ent key to accept the selection; the year is not required, only the day and months (dd/mm).
Press the # key to move to the end date and follow the procedure for programming the Start date. The #
key toggles between the Start and End dates for each holiday; the arrow (>) indicates which date is currently
selected.
To remove a programmed date, press the key. The date display returns to /.
Use the A or B key to move between the different holiday periods or enter the number of the holiday period
(1 – 10) to be programmed.
The holiday periods can only be programmed by the master manager and engineer. Users can access this
option, however, they can only view the programmed holiday dates.
To Next Page
Loading...
Need help?
General
