Galaxy 3 Series Programming Manual
27
Section 7: Modify Options
Option 41 – Time/Date (Quick Menu Option 7)
The Time/Date option can be accessed and modified by type 3.6 codes, the engineer and the remote code.
If any groups are locked (refer to option 49 = Datelock), then the time and date cannot be modified.
Modifying the Time and Date
The Time/Date option allows the system time and date to be modified. On entering this option the display
prompts for selection A = TIME B = DATE. Press the A key to select the time option; this allows a new
time to be entered. The time must be a valid four digit number — in the 24 hour format (hh:mm). The entry, if
valid, will be accepted immediately and the display is returned to the selection screen. Press the B key to
select the date option; this allows a new date to be entered. The date must be a valid 6 digit number - in the
day, month and year format (dd/mm/yy). The date entry, if valid, will be accepted immediately and the display
is returned to the selection screen.
NOTE: The time and date can be modified when groups are set.
Adjusting the Clock Speed
Variations in the accuracy of the clock speed can be compensated by pressing the # key while the A = TIME
B = DATE selection screen in the Time/Date menu is displayed. The keypads prompts for the Adjustment/
Week, in seconds, to be entered; the range is 0 – 120 seconds. If the clock requires to gain time, enter the
required number of seconds. If the clock requires to lose time, enter the required number of seconds and
press the key; the retards the clock speed.
41 - Time/Date
To Next Page
Loading...
Need help?
General
