Galaxy 3 Series Programming Manual
64
46 = Zone resistance
RIOs rev 1.2 and Smart PSUs rev 0.7 and above allow the zones to be programmed, with different resistance
ranges for zone status activation. This feature allows selection of End Of Line or Double Balanced zone
resistance types. The on-board zones can also be modified using this feature.
The “EOL/Dbl. Bal.” resistance types are selectable from this option. The default value is Double Balanced.
There are six preset pre-programmable resistance configurations:
1 = Preset 1 (BAL); 2 = Preset 1(EOL); 3 = Preset 2 (BAL); 4 = Preset 2 (EOL); 5 = Preset 3 (BAL);
6 = Preset 3 (EOL)
The tables that follows shows the resistance windows for each type:
51 - Parameters (cont’d)
Table 10. Preset value upper limits - double balanced
Table 11. Preset value upper limits - end of line
When selected, this will be the zone resistance range used by every zone on the system. Each zone on the
system can be further customised to a specific preset by using menu option 52.9, Resistance Select.
Preset 1 - 1k Preset 2 - 2k2 Preset 3 - 4k7
Tamper S/C 0 - 800 0 - 1800 0 - 3700
Low Res 800 - 900 1800 - 2000 3700 - 4200
Normal 900 - 1200 2000 - 2500 4200 - 5500
High Res 1200 - 1300 2500 - 2700 5500 - 6500
Open 1300 - 12000 2700 - 12000 6500 - 19000
Masked 12000 - 15000 12000 - 15000 19000 - 22000
Tamper O/C 15000 - infinity 15000 - infinity 22000 - infinity
Preset 1 - 1k Preset 2 - 2k2 Preset 3 - 4k7
Tamper S/C 0 - 800 0 - 1800 0 - 3700
Low Res 800 - 900 1800 - 2000 3700 - 4200
Normal 900 - 1200 2000 - 2500 4200 - 5500
High Res 1200 - 1300 2500 - 2700 5500 - 6500
Masked 1300 - 12000 2700 - 12000 6500 - 19000
Open 12000 - infinity 12000 - infinity 19000 - infinity
To Next Page
Loading...
Need help?
General
