Galaxy Flex Installer Manual Program Zones [52]
111
Scroll through the available channels, and then press ent to select the available audio
channel.
14=Fire Confirm
Use this attribute to enable this zone to be used as a fire confirm. A Fire zone with this
attribute enabled must be activated first.
15=Camera
Use this attribute to link the zone to a camera. When an alarm activation occurs, the camera
will record an image sequence for alarm verification.
Batch learn [52.3]
Use this option to learn a series of wireless detectors onto the system in a single operation.
Devices are added sequentially from the selected zone address.
1. Select a start zone address and press ent.
2. Insert the battery in the first detector and activate the tamper switch. The serial number
of the detector is recorded and displayed for 2 seconds. The panel provides a
confirming beep when each wireless detector is successfully learned.
If the signal strength is less than 3/10, the message Signal strength too low is
displayed for 2 seconds.
3. Repeat step 2 on all the remaining wireless detectors in turn.
Camera Zones [52.4]
Use this option to view only the zones that belong to camera PIRs
Zone Function menu
01 = Final 15 = PA Delay 32 = Set Log
02 = Exit 16 = PA Delay Silent 33 = Custom-A
03 = Intruder 18 = Spare 34 = Custom-B
05 = Security 19 = Fire 39 = Keyswitch Reset
07 = Entry 20 = Tamper 40 = Bell Fail
08 = Push Set 22 = Beam Pair 41 = Intr Low
09 = Keyswitch 23 = Battery Low 42 = Intr High
10 = Secure Final 24 = Line Fail 43 = PSU Fault
11 = Part Final 25 = AC Fail 44 = Fault
12 = Part Entry 26 = Log 45 = Entry 2
13 = PA 28 = Video 53 = Monitor
14 = PA Silent 29 = Video Exit
To Next Page
Loading...
Need help?
General
