Honeywell Galaxy Flex V3 Series - Test Options; Walk Test [31, Quick Menu 5]

Galaxy Flex Installer Manual Walk Test [31, Quick Menu 5]
57
Test options
Walk Test [31, Quick Menu 5]
Walk Test menu
31 = Walk Test

 1 = View – not used

 2 = Activate

 1 = Silent
 
  1 = Test all Zones
 
  2 = Selected Zones

 2 = Audible

 1 = Test All Zones

 2 = Selected Zones
View [31.1] Not used
Ac
tivate silent test on all zones [31.2.1.1] &
Activate audible test on all zones [31.2.2.1]
Use these options to starts an immediate walk test on all zones that have the omit attribute
enabled (refer to Program Zones [52]). Non-omittable zones are not included and remain
active throughout the test. If all zones are non-omittable NO ENTRIES is displayed.
Activate silent test on selected zones [31.2.1.2] &
Activate audible test on selected zones [31.2.2.2]
Use these options to select specific zones to test.
1. Navigate to a zone you want to test (use A or B or type a zone number).
Note: Each camera device on the system is allocated one of these addresses; 8001,
8011, 8021, 8031 or 8041.
2. Press # to toggle the test status to TEST.
3. Repeat the steps above until you have selected all the zones you wish to test.
4. Press ent to start the test.
Alternatively:
1. Press 

 to include all zones.
2
. Navigate to any zones you wish to exclude (press # to exclude a zone).
3. Press ent to start the test.