Honeywell Galaxy Flex V3 Series - Access Control [69]

Galaxy Flex Installer Manual Access Control [69]
183
Access Control [69]
The Access Control system is a complete security system. You can choose the type of access
control to use: either the MAX
4
or the door control module or both.
Access Control menu
69 = Access Control

 1 = Access Mode
 
  0 = Disabled
 
  1 = Enabled

 2 = MAX
 
  1 = MAX Address A/B to select line
  ent to start MAX search
  0 = Online, ent then key 0 - 7 to readdress MAX
  1 = Standalone
 
  2 = MAX Parameters A/B to move to required MAX address
 MAX XXX (select) # to display MAX address graphic
  ent to select:
 
  1 = Descriptor # = toggle upper case, lower case or
  library text
  * = delete last character
  A/B = move to character/word
  ent = assign character/word
  esc = save programming
 
  2 = Relay Duration  1 - 60 seconds (default = 05)
 
  3 = Open Timeout  0 - 60 seconds (default = 10)
 
  4 = Groups
   1 = Alarm Group
   2 = Group Restrict
   3 = Exit group
 
  5 = Emergencies Enable or disable option. If group mode is
  enabled, a separate enable is available for
  each group
 
  6 = Security
   1 = Nightlock  0-10 weekly schedules
   2 = Unlock Time  0-10 weekly schedules
   3 = Dual Mode
    0 = Disabled
    1 = Card and Card
    2 = Card and Pin
  
   4 = Dual Time  Option not available
 
  7 = Menu Recall
 
  1 = Menu Function (** = not used)
 
  2 = Menu Mode 1 = Card Held
 
  3 = Keypad ** = Keypad
 # = enable/disable


Continued on next page