Galaxy Flex Installer Manual Links [54]
135
Source Type * Modifier Example
Display
Notes
a) Not Used – This link is not operational
b) Zone Address Off *1014 When the zone is opened the link is active.
When the zone is closed the link is inactive.
On *1014 When the zone opens the first time, the link is activated.
When the zone opens a second time, the link is deactivated.
c) User Code Off *001 When the code is entered, the link is activated momentarily
only. This option is only practical to trigger a destination
event, for example, an output pulse.
On **001 When the code is entered the first time, the link is activated.
When the code is entered the second time the link is
deactivated.
d) Output Address Off #1014 When the output is on, the link is active.
When the output is off, the link is inactive.
On *#1014 When the output turns on the first time, the link is activated.
When the output turns on a second time, the link
deactivates.
e) MAX Address Off 01 When the MAX is swiped with a card the link activates
momentarily only. This option is only practical to trigger a
destination event, for example, an output pulse.
On *01 When the MAX is swiped with a card, the link is activated.
When the MAX is swiped a second time, the link
deactivates.
f) Weekly Schedule Off WK01 On time activates the link. Off time deactivates the link.
On *WK01 The first on time activates the link. The next on time
deactivates the link.
g) RF Fob –
A single press of the RF Fob button combination (
+ ),
activates the link, a second press deactivates the link. This
applies to any RF fob programmed on to the system
Table 8 Link Source
Destination Type * Modifier Notes
a) Not used – The link is not operational.
b) Zone Address – When the link is active, the zone is omitted from the system
c) User Code – When the link is active, the user's PIN and MAX card are not
operational.
d) Output Type – When the link is active, all outputs programmed with the selected
function are activated.
e) Output Address – When the link is active, the specific output address is switched on.
Please note that when using the output address as the destination, the
deactivation of the link will switch the output off immediately, overriding
any pulse time or latch mode of the output programming.
f) Keypad Address – When the link is active, the buttons on the keypad will not operate.
Table 9 Link Destination
To Next Page
Loading...
Need help?
General
