Honeywell Galaxy Flex V3 Series - Page 141

Galaxy Flex Installer Manual Communications [56]
141
ARC Notify [56.1] (continued)

 2 = Reports
 
  1 = ARC
  
   1 = Account No
  
   2 = Triggers
   
    Select a Trigger Event (01 to 19)
   
    1 = Status (0 = Disabled, 1 = Enabled)
   
    2 = Groups (if enabled)
  
   3 = Rx Sequence
   
    Direct entry of a string of receiver numbers 1-9
  
   4 = Audio Receiver
  
   5 = IP Check(ARC Report only)
  
   0 = Disable
  
   1 = Enable
 
  2 = Aux 1 
   Each one of these menu options has the same
  3 = Aux 2  sub-menu options as 1 = ARC above.
  
  4 = Aux 3 
 
  5 = DTMF
 
  1 = Account No
 
  2 = Channels 1-8
  
   1 = Channel 1
   
    1 = Op Function
   
    2 = Output Mode
   
    3 = Op Polarity
   
    4 = Restoral
  
   2 = Channel 2 
   
   3 = Channel 3 
   
   4 = Channel 4 
    Each one of these menu options
   5 = Channel 5  has the same sub-menu options
    as 1 = Channel 1 above.
   6 = Channel 6 
   
   7 = Channel 7 
   
   8 = Channel 8 
 
  3 = Rx Sequence (see 1 = ARC)

 3 = Comm Fail Time

 4 = Line Fail Path

 1 = Receiver (1-9, default = 1)

 2 = All