Galaxy Flex Installer Manual Assemble Zone [64]
173
Log [64.4]
This attribute determines which custom zone activations are logged. On selecting Log the
current selection is displayed. To change the selection press the # key, this toggles between
the Log options:
Disabled the custom zone activations are not logged.
Entry/Exit the custom zone activations only log during the setting and unsetting
procedure.
24 Hours all custom zone activations log (both in the set and unset states).
Alarms the custom zone only logs when an activation results in an alarm condition.
Note: The opening (+) and closing (–) of custom zones are recorded in the event log.
Assemble Zone Example
Assemble a zone that:
Activates Bells outputs when the system is set.
Activates Link-A outputs when the system is unset.
Generates an alarm condition when the system is part and full set.
Does not generate an alarm condition during the setting and unsetting procedure.
Acts as a terminator when the system is setting.
Logs all activation (in both set and unset states).
To program Assemble Zone:
(Assuming factory default settings)
1
. Select option 64=ASSEMBLE ZONES, and then press ent.
2. Select custom zone (1=Custom-A, 2=Custom-B), press ent. Outputs is displayed.
3. Press ent to select this option. 01=Bells is displayed.
4. Press #. Set is displayed.
5. Type 51. Link-A is displayed. Press #. Set is displayed.
6. Press #. Unset is displayed.
7. Press esc. Outputs is displayed.
8. Press A. Status
is displayed.
9. Press ent to select this option. Un
set Disabled is displayed.
10. Press A. Entry/ Exit Disabled is displayed.
11. Press A. Part Set Disabled is displayed.
12. Press #. Part Set Alarm is displayed.
To Next Page
Loading...
Need help?
General
