Galaxy Flex Installer Manual Access Control [69]
189
DCM [69.3]
Use this option to program door control module (DCM) access control readers. A DCM can
be fully integrated into the system, communicating on the AB lines, fully using the control
panel facilities. Each DCM can control up to two readers. The exit reader can be replaced
with a request to exit button.
When enabled, the options that are eligible for DCM programming are made available
throughout the menu, otherwise they do not appear, or appear as Option not Available.
Addressing the DCM
The DCM takes its address from an on-board rotary hex switch, or by setting with DIP
switches. Refer to Door control module on page 248.
DCM Parameters [69.3.1]
Use this option to define the operational features of each of the DCMs. On selecting this
option the address of the first DCM on the system is displayed along with the descriptor
currently assigned to it. If there are no DCMs on the system the message NO ENTRIES is
displayed.
Select the required DCM address using A and B, then press ent. The first parameter,
1=
Descriptor is displayed. Use A or B to move to the required parameter, and press ent.
DCM Descriptor [69.3.1.1]
Use this option to assign a name of up to 9 characters to each of the DCMs. This name is
assembled from the character set and/or library options. On selecting the Descriptor
parameter the currently assigned name is displayed on the top line - an underscore shows
where the next character will be positioned, and a selection of the alphabet is shown on the
bottom line - the cursor flashes on the letter L.
Press
to erase the characters already assigned to the name.
Use A or B to move the alphabet left or right until the required character is positioned
underneath the flashing cursor. When the required character is in position press ent to copy
the character to the description in the top line. Repeat this procedure to assemble the
required Descriptor.
DCM System Group [69.3.1.3]
This is the group that the DCM will report on for module tampers and diagnostics.
DCM Reader Descriptor (01 or 02) [69.3.1.5.01]
Use this option to assign a name of up to 9 characters to each of the readers. This name is
assembled from the character set and/or library options. On selecting the Descriptor
parameter the currently assigned name is displayed on the top line - an underscore shows
where the next character will be positioned, and a selection of the alphabet is shown on the
bottom line - the cursor flashes on the letter L.
Press
to erase the characters already assigned to the name.
To Next Page
Loading...
Need help?
General
