Appendix G: Peripherals Galaxy Flex Installer Manual
246
Connecting the Audio Interface Module to the PSTN
Connect the module to the panel PCB as shown below:
Control Panel PCB
PHONE
LINE
A
B
AB
Audio Interface PCB
Extension Phone
Incoming
PSTN Line
30 metres max.
from panel to
Audio Interface
PHONE LINE
A BAB
Figure 16 Audio Interface connected to PSTN
Connecting microphones and speakers
The audio channels will work with most line-level audio equipment. Use microphones with
a
pre-amplifier that delivers audio at line-level (3 V peak to peak). The module can transmit
audio to speakers that accept line-level signals. Please read any instructions that come with
your microphone regarding the adjustment of sensitivity. The module can be used with the
following Honeywell audio devices:
TP800/TP2-800GY Speaker and microphone unit
IS215TCE-MIC PIR detector with built-in microphone
DT7450-MIC Dual Tech detector with built-in microphone
TP800/TP2-800GY connection
Speaker and microphone connections
Audio Interface TP800/TP2-800GY
GND VS-*
+4.5 V VS+
CMD CMD
SPK RML
MIC ECOUT
TMP AP
AP*
* Connect these two points together to complete the tamper
To Next Page
Loading...
Need help?
General
