Galaxy Flex Installer Manual Codes [42, Quick Menu 7]
61
Default Codes
The system has three default codes: Manager, Engineer and Remote User.
Note: The user code before the manager code can be reserved as a Guard Patrol code but
is not programmed by default. This code can only be programmed by the installer
via the Engineer code.
Manager Code
The manager is authorized to modify the manager PIN, which cannot be deleted, and assign
MAX features to the code.
Note: The manager PIN can be reset to the default code (1234) by the engineer and remote
code using the Reset Mgr (Manager) parameter (refer to Reset MGR [51.21]). The
manager code defaults to group choice when groups are enabled. The manager is
able to toggle the group choice option on and off using the
key.
T
he manager code defaults to accessing the full menu. To access the quick menu, remove
the
assigned to the manager in the Modify Level option.
Guard Patrol Code
One user code can be reserved as a Guard Patrol code. This has the same level of access to
the system as a Manager code except it has no access to menu 42 for any user
administration. The Patrol code can only be programmed by the installer
Programming Codes
Users can modify their own PINs only.
User Codes [42.1]
Details of the first user (User 001) are displayed. The following typical information is
displayed on the keypad.
■
= pin assigned
= no pin assigned
You can scroll to the specific user or enter a user’s number, for example 023 or 069.
When the required code is displayed, press ent to select the modification options; 1=M
odify
PIN is displayed first.
No. of Codes Manager Engineer Remote User
Default PIN User No. Default PIN User No. Default PIN User No.
100 1234 98 112233 99 543210 100
001 User ■ m
L3 A 1234
user type
user number
user name
group mode
max card/tag/fob assigned
To Next Page
Loading...
Need help?
General
