EasyManuals Logo
Home>Honeywell>Security System>Galaxy Flex V3 Series

Honeywell Galaxy Flex V3 Series User Manual

Honeywell Galaxy Flex V3 Series
258 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #77 background imageLoading...
Page #77 background image
Galaxy Flex Installer Manual Remote Access [47]
77
PSTN Direct Access [47.1.0.0]
GSM Direct Access [47.1.1.0]
GPRS Direct Access [47.1.2.0]
Ethernet Direct Access [47.1.3.0]
When you select one of these options, a 40 minute remote access period is enabled on the
panel. Once access to the panel has been gained, it can be maintained indefinitely.
When the remote servicing connection is terminated, the access period remains valid for an
additional 15 minutes.
PSTN Call Back 1 to 5 [47.1.0.1 to 5]
GSM Call Back 1 to 5 [47.1.1.1 to 5]
GPRS Call Back 1 to 5 [47.1.2.1 to 5]
Ethernet Call Back 1 to 5 [47.1.3.1 to 5]
Use this option to pre-program up to five numbers (refer to Remote Access [56.4.3]). When
you select one of the numbers (1 to 5) and then press ent, the panel dials out to the pre-
programmed telephone number associated with the Call Back number.
If the number selected does not have a pre-programmed telephone number, the system
prompts for a number to be entered. Enter the required telephone number and press ent. The
pa
nel then dials out to the telephone number entered.
Note: The remote computer being dialled must have remote servicing software installed
and the Communication Server must be running.
Configure [47.2]
Use this option to configure the panel from a server. Programme System ID [51.15.1],
which must match the system ID at the server.
PSTN [47.2.0]
Use this option to select the on-board telecoms as the communication device.
PSTN Call Back 1 to 5 [47.2.0.1 to 5]
GSM Call Back 1 to 5 [47.2.1.1 to 5]
GPRS Call Back 1 to 5 [47.2.2.1 to 5]
Ethernet Call Back 1 to 5 [47.2.3.1 to 5]
When you select one of the numbers (1 to 5) and then press ent, the panel dials out to the
pre-programmed telephone number associated with the Call Back number.
Programme the call back number using [56.4].
Note: The remote computer being dialled must have remote servicing software installed
and the Communication Server must be running.
Auto Service [47.4]
You can program panels to communicate with remote servicing software automatically,
under three circumstances:

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Honeywell Galaxy Flex V3 Series and is the answer not in the manual?

Honeywell Galaxy Flex V3 Series Specifications

General IconGeneral
BrandHoneywell
ModelGalaxy Flex V3 Series
CategorySecurity System
LanguageEnglish

Related product manuals