Honeywell HCC80R - Binding the room device CM927 with the underfloor heating controller

Connecting devices (binding)
16
Binding room setpoint generators/sensors with the evohome controller
–
continued
Binding the underfloor heating controller
with the evohome controller
1
Press and hold the installation
button on the underfloor heating
controller for 2 seconds.
The LED lights up. The LED
of zone 1 flashes green.
2
Press the green connection button
at the evohome controller.
If binding was successful, the
orange LED of the underfloor
heating controller lights up.
Binding of the zone (room) is completed.
Repeat the process to bind further zones:
• Press the bind button at the underfloor heating
controller twice (skip red flashing LED).
The green LED of the first zone flashes green.
1