Configuration
Rev 3.01 19 Document 900.0258
10/05
SEQUENCE
buttons
When in Live mode, display another full live channel sequentially.
When in one of the multi-view formats, cause the DVR to sequence cameras in two
sequence modes:
Page mode: In Page mode, the DVR sequences through user-defined screen
layouts (pages).
Cameo mode: In Cameo mode, the bottom, right screen displays live cameras
sequentially. Press DISPLAY and SEQUENCE to access Cameo mode. Turn
Cameo sequencing on and off in the Main Monitor setup screen (see Main
Monitoring Setup Screen, page 59).
While in Sequence mode pressing SEQUENCE again will exit the Sequence
mode.
FREEZE Freeze the current live screen.
SPOT SPOT + the individual camera buttons display the selected camera on the spot
monitor. For the sequence display on the spot monitor, press SPOT +
SEQUENCE.
MENU Use to:
• Enter the Normal Setup screen. You must enter the administrator password to
access the Normal Setup.
• Close the current menu or setup dialog box.
• Access the Clip Copy menu. Pressing and holding the button while in
Playback mode enters the Clip Copy screen.
• Close the current menu or setup dialog box.
ALARM The ALARM button has two functions. First, it resets the DVR outputs including the
internal buzzer during an alarm. Second, it displays the event log when you are in
the Live Monitoring mode unless there is an active alarm. This operation can be
user password protected.
COUNTER Switch between displaying the remaining storage capacity on the screen.
PTZ Open a Pan/Tilt/Zoom screen which allows you to control properly configured
cameras.
Table 3-1 Front Panel Controls
Front panel
control
Press the button to … (cont’d)
To Next Page
Loading...
