Configuration
Rev 3.01 33 Document 900.0258
10/05
Figure 3-13 Storage Screen
Note When the DVR has more than four storage devices, you can
scroll through the list by selecting the Up and Down arrows
under the list.
The Type field displays the type and capacity of storage devices.
The Status field displays the device status or fault conditions. The choices are
described as follows:
Note After the S.M.A.R.T. Alert message displays, we recommend you
replace the hard disk drive, usually within 24 hours.
The C° field displays the temperature of the storage device.
The Usage field displays the device usage.
Table 3-2 Storage Screen Status Options
Status Description
Good The storage condition is normal.
Bad Data cannot be written on or read from the storage device.
S.M.A.R.T. Inop. Storage conditions are normal; however, the S.M.A.R.T.
monitoring is not working or is not supported.
S.M.A.R.T. Alert S.M.A.R.T. monitoring has detected a fault condition.
High Temperature S.M.A.R.T. monitoring has detected that the storage device
temperature exceeded the preset temperature threshold.
Not installed The storage device is not installed.
To Next Page
Loading...
