Honeywell HRHD9+ - Figure 3-46 LAN (DHCP) Setup Screen

Configuration
Rev 3.01 65 Document 900.0258
10/05
Caution When you change the port settings you must also change the port
settings on a PC running RAS. Refer to the RAS User Guide for
detailed information.
6. To save your changes and return to the Network Setup screen, highlight OK and
then press # . Select Cancel to exit the screen without saving the changes.
LAN Setup - DHCP
To set up a LAN (DHCP) connection:
1. On the LAN Setup screen, highlight the box beside Type, then press # .
2. Select DHCP, then highlight OK.
The system reads the current IP address of the DVR configured by DHCP
(Dynamic Host Configuration Protocol) network.
Figure 3-46 LAN (DHCP) Setup Screen
LAN Setup - ADSL
Note You cannot configure ADSL and modem at the same time. If the
DVR is networked via modem, the ADSL (PPPoE) option will not
be selected.
To set up a LAN ADSL connection:
1. On the LAN Setup screen, highlight the box beside Type, then press # .
2. Select ADSL (PPPoE), then highlight OK.